DELL OPTIPLEX GX260 MOTHERBOARD DRIVER

On the small desktop computer, remove the expansion-card cage and remove the power cables from the side of the hard drive. Connect any cables that should be attached to the card. Grasp the card by its top corners, and ease it out of its connector. Replace the computer cover. Installing a Hard Drive 1. Do not route card cables over or behind the cards.

Uploader: Fenrikazahn
Date Added: 2 March 2008
File Size: 53.24 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 78563
Price: Free* [*Free Regsitration Required]

RAM specs for Dell Optiplex GX260

Available from these sellers. Disconnect the power and audio cables from the interposer board.

To avoid damage to the memory module, press the module straight down into the socket with equal force applied at each end of the module. If you are installing a new card, remove the filler bracket to create an empty card-slot opening. Disconnect your computer and devices from their power sources. Discard used batteries according to the manufacturer’s instructions.

Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Now, when I went to Dell’s mootherboard and looked for RAM that’s compatible, it showed a Gc260 memory with the following specs: If your computer’s hard drive does not have a shroud, proceed to the next step.

  ELDOS CALLBACK FILE SYSTEM DRIVER

DELL OPTIPLEX GX SERVICE MANUAL Pdf Download.

Before you perform this procedure, see “Precautionary Measures. From inside the door, push in the two tabs on either side of the badge to release the badge.

Page 93 1 hinged lever 2 indented tab side view 2. Note the routing of the chassis intrusion cable as you remove it from the chassis. Open the computer cover.

Dell Optiplex Gx260 Motherboard 4t274 Pentium 4 2.26ghz CPU 1gb RAM Tray

What is multi core floating point speed? What is quad core mixed CPU speed? Disconnect the other end pptiplex the floppy-drive cable from the system board labeled DSKT. What is thermal design power TDP? A new battery can explode if it is incorrectly installed. Removing A Pci Card 3. Installing A Card 1 lever 5 card-edge connector 2 retention arm 6 card connector 3 filler bracket 7 riser board 4 card 8 card cage Installing a Card 1.

You have performed the steps in “Precautionary Replacing The Badge 1.

Page 29 1 edge connector 2 card 3 retention arm 4 card connector 5 filler bracket 3. Loading recommendations for this item If you are installing a microprocessor upgrade kit from Dell, discard the original heat sink.

  LOGIC3 PLAYSTATION 2 CONTROLLER ADAPTER FOR PC DRIVER DOWNLOAD

Not sure what OP was saying. Today’s hottest Amazon Ebay Newegg.

motherboards-cpu-ram – RAM specs for Dell Optiplex GX | DaniWeb

Leave delll release lever extended in the release position so that the socket is ready for the new microprocessor. Enter text from picture: There’s a problem loading this menu right now.

Remove motherbard memory modules and install them on the replacement board. Press in on the tabs on each side of the drive and slide the drive up and out.

Remove the filler bracket by raising the hinged lever and sliding the bracket up.

What is single core mixed CPU speed? Facing the front of the computer, use your fingers to remove the front- panel cover.